Hardware Setup; Connect Host And Cradle - Symbol Series 3100 Product Reference Manual

Hardware Setup

Connect Host and Cradle

Power Supply Cord
Figure 2-1. Cradle Setup for 3100/3110 and 3500/3510 Initialization
The procedure for connecting 1- and 4-slot cradles is the
Note:
same.
1. Plug the RS-232 serial cable's connector into the cradle's communication port.
2. Connect the other connector to the host computer's serial (COMM) port.
3. Connect the power supply cord's round plug to the power connector on the side
of the cradle (3165: power supply p/n 59915-00-00 for domestic use, 60507-00-00
for international use; 3166: power supply p/n 60153-00-00 for domestic use and
60174-00-00 for international use).
4. Connect the power supply's AC plug to a standard electrical outlet.
The green and red indicators light for about 3 seconds, blink for 3 seconds, then go
out.
5. Place the terminal in the cradle. Verify that the terminal is OFF.
6. Go to Loading the Program.
Host Computer
Power
Connector
Comm Port
Batch and Spectrum One Terminal Setup
Serial Null Modem Cable
2-5