Series 3100/3500 Product Reference Guide
Error Messages
31X0/35X0
If ERR3000 is loaded in the system configuration, the terminal displays the following
messages to indicate error conditions that affect system performance. A message is
usually accompanied by one or more beeps, after which the system returns to its
previous status.
The application can change the actual wording of the messages or disable messages.
The messages listed in Table 5-1, Error Messages are representative. Refer to the
application's documentation for further information.
Message
Double Key Error
Low Battery
Replace Battery
Power Fault
5-4
Table 5-1. Error Messages
Two or more keys were pressed at the same time. This
does not include boot sequences (refer to Chapter 4,
Operating the Series 3100/3500, for boot sequences).
The battery pack should be recharged or replaced as soon
as possible.
Replace or recharge the battery pack immediately. After
this message is displayed, the system shuts off. You may
not be able to power it on again until the battery pack is
charged.
The last power off was caused by a power failure. This
occurs, for example, if the battery pack is removed while
the terminal is on or the batteries fail suddenly.
Explanation