Download Over The Network: Bootp (Default); Initiate Network Connection - Symbol Series 3100 Product Reference Manual

Series 3100 / 3500 Product Reference Guide

Download Over the Network: BOOTP (Default)

Initiate Network Connection

1. Cold boot the terminal.
Note: Verify that terminal is OFF before cold booting.
a. Press and hold <A+B+D>.
b. Press and release <PWR>.
c. Release <A+B+D>.
The terminal boots DR-DOS and loads the radio driver while displaying a series of
boot messages.
2. Enter a new Net Id, obtained from the Network Administrator, in the Configurator
(DFG24).
This process should only be required on the first-time,
Note:
out-of-box network connection.
On first boot , the terminal automatically brings up the Configurator screen for
entering a new Net Id:
3. To enter the new Net Id:
a. Use the <UpArrow> and <DownArrow> to cursor to Net Id.
b. The default Net Id appears in hex format. Backspace over the existing value,
type a new value in the range 102-1FE (in hex, not case sensitive), and press
<ENTER>.
c. If you are using a BOOTP or DHCP server, cold boot the terminal and proceed
to the section, Terminal Attempts to Associate with Access Point.
4. If you are not using a BOOTP or DHCP server, enter the following parameters:
- Subnet Mask
3-8
CONFIGURATOR 1.XX
View config params
Net Id
Subnet Mask
Default Router
Terminal IP Address
Exit
↑
, Clear, Enter