Symbol Series 3100 Product Reference Manual page 79

To connect the terminal to a printer:
1. Plug the passive cable's 10-pin RJ-41 connector into the Series 31XX/35XX
terminal's serial port.
2. Plug the DB-9 connector into the communications port on the printer.
3. Start the communications program.
3115 CCA
To connect the terminal to a modem using the 3115 CCA:
1. Plug the 10-pin RJ-41 connector into the base of a Series 31XX/35XX terminal.
2. Insert a female-to-male gender changer on the female DB-25 connector before
plugging the connector into the modem.
3. Start the communications program.
Note: The CCA is shipped set for RS-232 communications with a PC.
To use the CCA with a modem may require changing the
internal communications settings. Refer to the Installation
Instructions (P/N 70-11314-XX).
Integrated: Direct Connect (PDT 3100, 3110, 3124 only)
If the terminal is equipped with a direct connect modem, connect the modem as
follows:
1. Power the terminal off.
2. Release the hand strap on the back of the terminal.
3. Detach the plug covering the modem jack on the back of the terminal
Operating the Series 3100/3500
4-33