Starting Communications; Ending Communications - Symbol Series 3800 Reference Manual

Series 3800 Product Reference Guide

Starting Communications

1. The terminal is ready to receive the program from the host PC and displays:
2. Press <ENTER> on the terminal.
3. Press <ENTER> on the host computer. SENDHEX begins transmitting the program
image. When communications are established, the terminal displays:
During program loading, the display shows the program segment address being
transferred (XXXX).
4. When the transmission is complete, the terminal displays:
A status of 0000 (all zeros) indicates a successful transter. Other status values
indicate an error. These values are provided in Appendix B, Communications Status
Codes.
If you received an error, press <Clear> on the terminal to return to the Command
Mode main menu.

Ending Communications

To return to the Command Mode main menu:
1. Press <Clear> on the terminal.
2. Power down the terminal.
3. Detach any cables connected to the terminal.
4. Reboot the terminal using the appropriate cold boot sequence described in Chapter
5, Operating the Series 3800, in the section Booting a Series 3800 Terminal .
3-6
Comm Parameters
Start? <ENT>
Program loader
Receiving: XXXX
Program loader
Status 0000