Set Communications Parameters - Symbol Series 3100 Product Reference Manual

Set Communications Parameters

Host
1. Start the Communications program on the host PC.
2. Set up the host communication parameters (these parameters must match the
terminal's parameters). At the DOS prompt on the host, enter:
RCVHEX <filename.hex> <baud rate> <comport#>
Typical parameters are:
38400 bps
7 bit data
Odd parity
Xon/Xoff flow control
Terminal
1. Boot the terminal to Command Mode (refer to Chapter 4 for the appropriate key
sequence).
2. Select the Memory Transfer function from the Command Mode menu. Use
<UpArrow> or <DownArrow> to scroll through the command mode options until
Memory Transfer is displayed, and press <Enter>.
3. Select the range of memory to transfer by pressing the first letter of the desired
range (All, Range, or None), or use the <UpArrow> or <DownArrow> and press
<Enter>.
If you select All, the program skips to the range verification screen (step 7).
If you select Range, the screen displays:
4. Specify a range of RAM by setting the Start and End addresses.
- Use <RightArrow> and <LeftArrow> to move the cursor to the digit to be
changed
- Use <UpArrow> and <DownArrow> to change the values.
Type a range and press <Enter>.
RAM
Use Arrow Keys
Start End
00000 9FFFF
Error Recovery and Troubleshooting
5-15