Cub Cadet 8454 Service Manual page 64

CHAPTER 2 8454
3) Start spring
1. Remove the start spring (1) from the fork lever 1 (2).
(When reassembling)
• Be careful not to drop the start spring into the gear
case.
• Hook the start spring so that the longer hook is on
the fork lever side.
4) Fan drive pulley
1. Install the stopper to the flywheel so that the crank-
shaft may not turn.
2. Flatten the metal lock and loosen the crankshaft
nut (2).
3. Remove the fan drive fan drive pulley (1).
Tightening Crankshaft
torque nut
5) Gear case
1. Remove the gear case.
(When reassembling)
• Stick the O-ring (1) to the gear case with thin grease
to prevent from coming off during reassembling.
• Apply grease to the crankshaft oil seal lip on the
gear case and take care not to damage it when
installing.
• Apply liquid gasket (three bond 1215 or equivalent)
to the both sides of gear case gasket.
2-42
K&T Saw Shop 606-678-9623 or 606-561-4983
www.mymowerparts.com
137.3 ~ 156.9 N·m
14.0 ~ 16.0 kgf·m
101.3 ~ 115.7 lbf·ft
(1) Start Spring
(1) Fan Drive Pulley
(1) O-Ring
569W266A
(2) Fork Lever 1
569W267A
(2) Crankshaft Nut
569W268A
D569-W02 May-2003