Cub Cadet 8454 Service Manual page 303

F. PRE-HEAT CONTROL OPERATION LAMP
(9)
When the key switch is in the "ON" position, light will
illuminate.
When the whether is cold, remain the key switch in the
"ON" position before starting for a while or until the lamp
goes out.
During this period, glow plug and combustion chambers
are heated up and the engine becomes easier to start.
G. HYDRAULIC FILTER WARNING LAMP (10)
If the hydraulic filter is restricted or the vacuum pres-
sure of filter is increased over specified level, this lamp
turns on.
Stop the engine and check the hydraulic line.
H. HEADLAMP HIGH-BEAM INDICATOR (11)
The light will be illuminated when the headlamp switch
is located at high beam position.
I. PARKING BRAKE WARNING LAMP (12)
The light will be illuminate when the parking lever is
pulled up.
J. 4WD LAMP (13)
The light will be illuminate when the front wheel drive
lever is pushed down.
K. TURN SIGNAL LAMP INDICATOR (14 AND 15)
Light will be flash when operating the turn signal switch
to the left or right.
• If the turn signal lamp is flashing faster
than normal condition, check the
lamps. One of the lamps must be mal-
functioned.
CAUTION
D569-W03 June-2003
K&T Saw Shop 606-678-9623 or 606-561-4983
www.mymowerparts.com
ELECTRICAL SYSTEM
(1) Turn Signal Switch
569W803A
8-5