Disassembling Brake Case - Cub Cadet 8454 Service Manual

5.5 DISASSEMBLING BRAKE CASE

Brake Case
1. Loosen and remove the nut (1), spring washer (2),
plain washer (3), brake can lever (4), bolt (5) and
spring washer (6).
2. Separate the brake case (7), tapping the brake case
lightly.
(When reassembling)
• Apply grease to the brake ball seats (16).
(Do not grease excessively.)
• Before installing the brake case (7) to the transmis-
sion case, install the cam plate (14) to the trans-
mission case.
Tightening Brake case
torque mounting bolt,
nut
Brake cam lever
mounting nut
It is Possible to Disassemble as Shown in the
Figure Above.
(When reassembling)
• Place the brake discs (9) so that the hole "A" of the
second disc should be overlapped 70% or more.
• Apply grease to the O-ring (12) and take care not to
damage them.
D569-W02 May-2003
K&T Saw Shop 606-678-9623 or 606-561-4983
www.mymowerparts.com
77.5 ~ 90.2 N·m
7.9 ~ 9.2 kgf·m
57.1 ~ 66.5 lbf·ft
123.6 ~ 147.1 N·m
12.6 ~ 15.0 kgf·m
91.1 ~ 108.5 lbf·ft
(1) Nut
(2) Spring Washer (10) Plate
(3) Plain Washer (11) Snap Ring
(4) Brake Cam Lever (12) O-Ring
(5) Bolt (13) Brake Cam
(6) Spring Washer (14) Cam Plate
(7) Brake Case (15) Ball
(8) Gasket (16) Ball Seat
BRAKE
569W725A
(9) Disc
569W726A
7-15