•
Differential Gear Assembly
1. Remove the differential support, nothing the num-
ber of left shims.
2. Take out the differential gear assembly, nothing the
number of right shims.
(When reassembling)
•
Check the spiral bevel gear for wear or damage. If it
is no longer serviceable, replace it.
•
Then, also replace the spiral bevel pinion.
•
Be sure to install the differential support to position
the casting mark " " on it upward.
•
Use the same number of shims as before
disassembling.
Tightening
Differential
torque
support mounting
screws
•
Bearing and Differential Lock Shifter
1. Secure the differential gear in a vise.
2. Remove the differential lock shifter and taper roller
bearing as a unit with a puller.
•
Differential Case Cover and Differential
Side Gear
1. Remove the differential case cover (3).
2. Remove the differential side gear (1) and differen-
tial side gear washer (2).
(When reassembling)
•
Apply Liquid lock (Three Bond 1372 or equivalent)
to the differential case cover mounting screws.
Tightening
Differential case
torque
mounting screws
D569-W02 May-2003
K&T Saw Shop 606-678-9623 or 606-561-4983
www.mymowerparts.com
48.1 ~ 55.9 N·m
4.9 ~ 5.7 kgf·m
35.5 ~ 41.2 lbf·ft
48.1 ~ 55.9 N·m
4.9 ~ 5.7 kgf·m
35.5 ~ 41.2 lbf·ft
TRANSMISSION SYSTEM
(1) Differential Side Gear
(2) Differential Side Gear Washer
(3) Differential Case Cover
569W4A3A
569W4A4A
569W4A5A
4-65