Cub Cadet 8454 Service Manual page 217

e . Relief Valve (Hydraulic Block)
• As shown in the figure, a guide is attached at pop-
pet (6) and valve chamber D.C (damping chamber)
located at the bottom of the guide piston. Intake of
valve enable through sliding part of guide and clear-
ance of seat (5) to chamber and minimizes valve
vibration as damping effect of chamber.
• If oil pressure does not exceed the specified pres-
sure of the relief valve, relief valve will not operate
and oil flows from the hydraulic pump to the inlet of
hydraulic cylinder.
• As the oil pressure of circuit increases, that of damp-
ing chamber D.C. increases. If pressure exceeds
the specified valve and the spring tension, the valve
will open to flow oil through port T to transmission
case. If oil is discharged sufficiently and its pres-
sure is less than the specified, the valve will be
closed.
Relief valve setting
pressure
Engine speed
Oil temperature
D569-W02 May-2003
K&T Saw Shop 606-678-9623 or 606-561-4983
www.mymowerparts.com
16.2 ~ 17.2 Mpa
16.5 ~ 175 kgf/cm 2
2.347 ~ 2.489 psi
Max.
40 ~ 60 °C
104 ~ 140 °F
HYDRAULIC SYSTEM
D.C: Damping Chamber
C: Cylinder Port
(1) Washer
(2) Shim
(3) Plug
569W625A
569W626A
P: Pump Port
T: Tank Port
(4) Front Hydraulic B Lock
(5) Seat
(6) Poppet
6-23