Cub Cadet 8454 Service Manual page 130

CHAPTER 4 8454
D. SEPARATING CLUTCH HOUSING
Propeller Shaft
1. Slide the propeller shaft cover (4), (5) after remov-
ing the bolt (9).
2. Tap out the spring pin (10) and then slide the cou-
pling (2) to the front.
(When reassembling)
• Apply grease to the splines of the propeller shaft.
Hydraulic Pipes
1. Remove the brake rod (4) and delivery pipe (3).
2. Remove the delivery pipe (2).
3. Slide the rubber hose (1).
(When reassembling)
• Reinstall the pipe clamps securely.
Tightening Join bolt for
torque delivery pipe (3)
and front
hydraulic block
Joint bolt for
delivery
pipe (2) and
regulator valve
Separating the Engine From Clutch Housing
1. Place the jack under the clutch housing case.
2. Hoist the engine by the nylon lift strap at the tank support.
3. Remove the engine mounting screws, and then pull
the engine to the front.
(When reassembling)
• Apply grease to the splines.
• Apply liquid gasket (There Bond 1208D or
equivalent) to joint face of the engine and clutch
housing.
Engine and clutch
Tightening
housing
torque
mounting screws,
nuts
Engine and clutch
housing
mounting stud
bolts
4-26
K&T Saw Shop 606-678-9623 or 606-561-4983
www.mymowerparts.com
(1) Propeller Shaft
(2) Coupling
(3) Cir-Clip
(4) Propeller Shaft Cover
(5) Propeller Shaft Cover (10) Spring Pin
49.0 ~ 58.8 N·m
5.0 ~ 6.0 kgf·m
36.2 ~ 43.4 lbf·ft
34.3 ~ 39.2 N·m
3.5 ~ 4.0 kgf·m
(1) Rubber hose
25.3 ~ 28.9 lbf·ft
(2) Delivery pipe
77.5 ~ 90.2 N·m
7.9 ~ 9.2 kgf·m
57.1 ~ 66.5 lbf·ft
39.2 ~ 49.0 N·m
4.0 ~ 5.0 kgf·m
28.9 ~ 36.2 lbf·ft
569W437A
(6) O-Ring
(7) O-Ring
(8) O-Ring
(9) Bolt
569W438A
(3) Delivery pipe
(4) Brake rod
569W439A
D569-W02 May-2003