Cub Cadet 8454 Service Manual page 134

CHAPTER 4 8454
B. CLUTCH HOUSING AND MIDDLE CASE
a. To Disassembling
1. Remove M12 bolts (3) at six places and nuts (4) at
two places to loosen clutch housing (1) and middle
case (2).
b. To Assemble
1. Remove any foreign substance cleanly out of as-
sembling surfaces of clutch housing (1) and middle
case (2) and replace the packing with new one for
assembly.
2. Tighten nuts at two places and M12 bolts at six
places while aligning the position of parallel pins
at two places and stud bolts at two places.
Tightening Tightening stud of
torque clutch housing
and middle case
(A)
Tightening bolt of
clutch housing
and middle case
(B)
Tightening nut of
clutch housing
and middle case
(C)
1. Carefully tighten M12 bolts when as-
sembling
M12 x 40 (four places): middle case, part A
CAUTION
M12 x 60 (two places): middle case, part B
M12 stud bolts (two places): middle case,
part C
2. Parallel pin spec. (outer diameter x
length): 10 x 20 mm (0.393 to 0.787 in.)
4-30
K&T Saw Shop 606-678-9623 or 606-561-4983
www.mymowerparts.com
34.3 ~ 49.0 N·m
3.5 ~ 5.0 kgf·m
25.3 ~ 36.1 lbf·ft
128.5 ~ 145 N·m
13.1 ~ 14.8 kgf·m
94.7 ~ 106.9 lbf·ft
103 ~ 117.7 N·m
10.5 ~ 12.0 kgf·m
78.9 ~ 86.8 lbf·ft
(1) Clutch Housing
(2) Middle Case
569W444A
(3) Bolt
(4) Bolt
569W445A
D569-W02 May-2003