Cub Cadet 8454 Service Manual page 259

d. To Assemble the Relief Valve
1. Pick up the spring guide part with a pin set to insert
poppet (25) into the flange area of the housing.
2. Insert spring (26) and damper collar (27).
3. Insert O-ring into the relief adjusting plug (29) to
tighten with the housing.
• Adjust pressure of the steering relief
valve when
completed.
CAUTION
Variable amount of pressure per revo-
lution of the relief adjusting plug (29)
is 15 kgf/cm
e . Caution for Assembly of the Power Steer-
ing Unit
1. Be careful not to allow damages on the mechanically
processed ends of the sleeve, spool and housing.
2. Perform disassembly and repair at a clean place,
and remove any dust or foreign substance on joints
around the main body of the product with a wire
brush.
3. Be thoroughly careful not to cut of damage any parts
by body drop or contact when handling.
4. Disassembly of the power steering unit shall be as
specified in this manual, however not recommended
to if possible.
D569-W02 May-2003
K&T Saw Shop 606-678-9623 or 606-561-4983
www.mymowerparts.com
the assembly is
2 (213 psi).
HYDRAULIC SYSTEM
(25) Poppet
(26) Spring
(27) Damper Collar
(28) O-Ring
569W695A
(29) Adjusting Plug
(33) Screw
(34) Retainer Plate
(35) Ball
6-65