Bevel Gear Case And Front Axle Case - Cub Cadet 8454 Service Manual

5.2 BEVEL GEAR CASE AND FRONT AXLE CASE

(1) Bolt
(2) Bearing Cover
(3) Shim
(4) Ball Bearing
(5) 16 Bevel Gear
(7) Plug
A. TO DISASSEMBLING
1. Remove six M8 washer mounting bolts to loosen
bearing cover (2).
2. Remove shim (3), 6208 ball bearing (4) and 16 bevel
gear (5) at the top of bevel gear case (16).
3. Remove plug (7) at the bottom of front axle case
(15).
4. Remove snap ring (8) and Disassembling shim (9),
6208 ball bearing (10), 13 bevel gear (11) and bevel
gear shaft (12).
5. Remove mounting snap ring (14) of 6011 ball bear-
ing (13).
6. Separate front axle case (15) and bevel gear case
(16).
7. Remove 6014 ball bearing (17), snap ring (18) and
6011 ball bearing (13) inside front axle case (15).
8. Remove housing (19), O-ring (20) and floating seal
(21) at the bottom of bevel gear case (16).
B. TO ASSEMBLE
1. Install 6011 ball bearing (13), snap ring (18) and
6014 ball bearing (17) on front axle case (15).
2. Install O-ring (20), housing (19) and floating seal
(21) on the assembled of front axle case (15) and
bevel gear case (16).
D569-W02 May-2003
K&T Saw Shop 606-678-9623 or 606-561-4983
www.mymowerparts.com
(8) Snap Ring
(9) Shim
(10) 6208 Ball Bearing
(11) 13 Bevel Gear
(12) Bevel Gear Shaft
(13) 6011 Ball Bearing
(14) Snap Ring
(15) Front Axle Case
(16) Bevel Gear Case
(17) 6014 Ball bearing
3. Install front axle case (15) on bevel gear case (16)
and tighten snap ring (14) at the bottom of 6011 ball
bearing (13).
4. Install 13 bevel gear (11), 6208 ball bearing (10),
shim (9) and snap ring (8) on front axle case (15).
5. Install plug (7) after greased on its contacted sur-
face on front axle case (15).
6. Sub-assemble snap ring (22), 16 bevel gear (5) and
6208 ball bearing (4) on bevel gear shaft (12) and
fix bevel gear shaft (12) and 13 bevel gear (11) as
splined by pushing downward from the top of the
bevel gear case (16).
7. Place shim (3) on the top of 6208 ball bearing (4)
and fix bearing cover (2) with M8 washer mounting
bolt (1).
Tightening Mounting bolt (1)
torque of the bearing
cover
• Support the bottom when disassem-
bling front axle case to keep the case
from falling down.
CAUTION
• Install plug (7) after applying sealant
on.
→ Three Bond 1216 or its equivalent.
FRONT AXLE
569W519A
(18) Snap Ring
(19) Housing
(20) O-Ring
(21) Floating Seal
(22) Snap Ring
23.5 ~ 27.4 N·m
2.40 ~ 2.80 kgf·m
17.3 ~ 20.2 lbf·ft
5-13