Cub Cadet 8454 Service Manual page 293

Separating the Engine from Clutch Housing
1. Place the jack under the clutch housing case.
2. Hoist the engine by the nylon lift strap at the tank
support.
3. Remove the engine mounting screws, and then pull
the engine to the front.
(When reassembling)
• Apply grease to the splines.
• Apply liquid gasket (There Bond 1208D or
equivalent) to joint face of the engine and clutch
housing.
Tightening Engine and
torque clutch Housing
mounting
Screws, nuts
Engine and
clutch Housing
mounting Stud
bolts
Hydraulic Pipes
1. Loosen the screws (1), bolt (2) and remove the suc-
tion pipe (3).
2. Remove the pipe (4), (5), (6), (7).
D569-W02 May-2003
K&T Saw Shop 606-678-9623 or 606-561-4983
www.mymowerparts.com
77.5 ~ 90.2 N·m
7.9 ~ 9.2 kgf·m
57.1 ~ 66.5 lbf·ft
39.2 ~ 49.0 N·m
4.0 ~ 5.0 kgf·m
28.9 ~ 36.2 lbf·ft
(1) Screw
(2) Bolt
(3) Suction Pipe
(4) PTO Pipe 1
BRAKE
569W722A
569W723A
(5) Pipe 1
(6) Pipe 2
(7) PTO Pipe 2
7-13