Cub Cadet 8454 Service Manual page 138

CHAPTER 4 8454
F. AUXILIARY SHIFT COVER
a. To Disassembling
1. Remove auxiliary shift cover bolt (11) on the middle
case side to loosen auxiliary shift cover (10) in a
body.
2. Disassembling the shifting arm (7) from the auxil-
iary shift cover (10).
b. To Assemble
1. Fix bush (8) with shift arm (7).
2. After fixing O-ring (6) with shift arms (7), where
greased, insert shift arms (7), into the hole of auxil-
iary shift cover (10).
3. Fix auxiliary shift cover with M10 washer mounting
bolt (11) as aligning shift arms (7), of auxiliary shift
cover (10) ass'y with the fork groove.
Tightening Tightening bolt of
torque auxiliary shift
cover
• Outer diameter Factory
of the shift arm of spec.
the auxiliary shift
• Inner diameter of
the shift arm of
the auxiliary shift
• Outer diameter
of the shift arm
of the creep shift
• Be sure to apply grease on O-rings be-
fore fixed with shift arms.
• If the packing (2) has been damaged,
CAUTION
surely replace it with new one.
4-34
K&T Saw Shop 606-678-9623 or 606-561-4983
www.mymowerparts.com
48.0 ~ 55.9 N·m
4.9 ~ 5.7 kgf·m
35.4 ~ 41.2 lbf·ft
• 17.975 ~ 17.957 mm
(0.707 ~ 0.706 in.)
• 30.000 ~ 29.979 mm
(1.181 ~ 1.180 in.)
• 20.021 ~ 20.000 mm
(0.788 ~ 0.787 in.)
(1) Shift Fork
(2) Fork Rod
(3) Spring Pin
(4) Ball (10) Shift Cover
(5) Spring (11) Bolt
(6) O-Ring
569W450A
(7) Shift Arm
(8) Spacer
(9) Gasket
D569-W02 May-2003