Expansion cards
Figure 63: Installing expansion cards (B)
Ê Make sure that the rear slot cover is positioned in the designated groove and
that the expansion card is fully seated in the slot (1).
Ê Secure the expansion card with the screw (2).
6.3.1.4
Concluding steps
Perform the following steps:
"Installing SAS RAID controller" on page 124
Ê
Ê Installing the 3-pin cable onboard.
"Installing the riser module" on page 70
Ê
"Installing the server node in the Dual Node Cluster Server" on page 72
Ê
Ê Reconnect all external cables.
"Switching on the server node" on page 73
Ê
"Updating RAID controller firmware" on page 83
Ê
"Enabling boot watchdog functionality" on page 84
Ê
"After replacing / upgrading LAN controllers" on page 92
Ê
116
Upgrade and Maintenance Manual
(if applicable)
(if applicable)
(if applicable)
CX272 S1