Figure 70: Installing a SAS RAID controller (B)
Ê Make sure that the rear slot cover is positioned in the designated groove and
that the expansion card is fully seated in the slot (1).
Ê Secure the expansion card with one screw (2).
6.4.1.5
Concluding steps
Perform the following steps:
Ê Installing the 3-pin cable onboard.
"Installing the riser module" on page 70
Ê
"Installing the server node in the Dual Node Cluster Server" on page 72
Ê
Ê Reconnect all external cables.
"Switching on the server node" on page 73
Ê
"Updating RAID controller firmware" on page 83
Ê
"Enabling boot watchdog functionality" on page 84
Ê
CX272 S1
Upgrade and Maintenance Manual
Expansion cards
129