Section 10-Shrouds And Frame; Removing/Installing The Top Shroud; Removing; Installing - Invacare Pronto M50 Service Manual

SECTION 10—SHROUDS AND FRAME
SECTION 10—SHROUDS AND
FRAME
WARNING
After any adjustments, repair or service and before use, make sure that all attaching
hardware is tightened securely - otherwise injury or damage may result.
Before performing any maintenance, adjustment or service verify that On/Off
switch on the joystick is in the Off position.
To prevent cracking the plastic shroud material, DO NOT overtighten the
mounting screws.

Removing/Installing the Top Shroud

NOTE: For this procedure, refer to FIGURE 10.1 on page 88.

Removing

1. Disconnect the joystick. Refer to Disconnecting/Connecting the Joystick on page 123.
2. M61 Wheelchairs Only - Remove the joystick cable from the clip on the top shroud.
3. Remove the seat. Refer to Removing/Installing the Seat Assembly on page 50.
4. Remove the top shroud by pulling it up off the base frame.

Installing

1. Pull joystick cable through the center hole in the top shroud.
2. Place the top shroud on the base frame and push downward to engage the hook and
loop straps.
3. M61 Wheelchairs Only - Secure the joystick cable using the clip on the top shroud.
4. Install the seat assembly. Refer to Removing/Installing the Seat Assembly on page 50.
5. Connect the joystick. Refer to Disconnecting/Connecting the Joystick on page 123.
87
Part No. 1125075 Pronto® Series