Depth - Invacare Pronto M50 Service Manual
Invacare pronto series power wheelchair service manual
Hide thumbs
Also See for Pronto M50:
- Parts catalog (100 pages) ,
- Owner's manual (96 pages) ,
- Brochure & specs (2 pages)
Table of Contents
Advertisement
SECTION 8—FRONT RIGGINGS/FOOTBOARD
Bottom View of
Footboard
FIGURE 8.9 Adjusting the Footboard Assembly - Angle
Depth
NOTE: For this procedure, refer to FIGURE 8.10.
1. Remove the quick release pin that secures the footboard assembly to the wheelchair
frame.
Make sure the detent balls of the quick-release pin are fully released and beyond the
outer edge of the tube before operating the wheelchair. Otherwise, injury and/or
damage may result.
Keep detent balls clean.
2. Adjust footboard to one of three mounting positions.
3. Install the quick release pin. Make sure the detent balls of the quick-release pin are
fully released and beyond the outer edge of the tube (Detail "A").
Mounting
Hole
Quick
Release Pin
FIGURE 8.10
Pronto® Series
Set Screw, Washer
and Jam Nut
WARNING
Top Shroud
Three Depth
Adjustment Holes
Footboard
Assembly
Detent
Ball
Adjusting the Footboard Assembly - Depth
DETAIL "A" - BOTTOM VIEW OF
FOOTBOARD
Outer Edge
of Tube
80
Footboard
Assembly
Quick Release Pin
Detent Balls
Part No. 1125075
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
