Removing/Installing The Seat Pan - Invacare Pronto M50 Service Manual

Mounting Screws
1-inch Adjustment
FIGURE 7.3 Adjusting the Seat Height - M61 Wheelchairs

Removing/Installing the Seat Pan

NOTE: For this procedure, refer to FIGURE 7.4 on page 64.
NOTE: Note of the position and orientation of the mounting hardware, seat positioning straps and
quick release pin tabs for installing of the seat pan.
NOTE: Reverse this procedure to install the seat pan. Torque locknuts to 75-inch-lbs.
1. Perform one of the following:
• Remove seating system. Refer to manufacturers seating system installation
instructions.
• Remove cushion by pulling up to release hook and loop strips. Remove cushion
from seat pan.
2. Remove the two rear mounting screws, quick release pin tabs, spacers and locknuts
that secure the seat pan and seat positioning straps to the seat frame.
NOTE: The two front mounting screws, spacers and locknuts also secure the front rigging support
tubes to the seat frame.
3. Remove the four mounting screws, locknuts and four spacers securing the seat pan to
the seat frame (FIGURE 7.4).
4. Remove the seat pan from the seat frame.
Part No. 1125075
Spacers
Seat Frame Plate
Seat Frame
1-inch Adjustment
Spacers
Washers
Locknuts
63
SECTION 7—ASBA SEAT
Seat Pivot
Pronto® Series