Removing/Installing The Elevate Actuator; Removing - Invacare Pronto M50 Service Manual

SECTION 10—SHROUDS AND FRAME
3. Hook the top of the SureStep spring to the hook on the walking beam.
4. Install the front headtube assembly. Refer to Removing/Installing the Front Headtube
Assembly on page 83.
Shoulder Screw
FIGURE 10.7 Removing/Installing the Walking Beam

Removing/Installing the Elevate Actuator

NOTE: For this procedure, refer to FIGURE 10.8 on page 96.
NOTE: This procedure applies to M61 wheelchairs only.

Removing

1. Remove the seat. Refer to one of the following procedures:
• Van Seats - Refer to Removing/Installing the Seat Assembly on page 50.
• ASBA Seats - Refer to Removing/Installing the Seat Assembly on page 59.
2. Remove the batteries. Refer to Removing/Installing Batteries from/into Battery Tray
on page 99.
3. Disconnect the actuator connector from the controller connector (Detail "A").
4. Cut the three tie-wraps securing the actuator cable to the frame (Detail "A").
5. Remove the four hex screws and washers securing the elevate actuator to the bottom
of the frame.
6. Remove the four button screws and washers securing the elevate actuator to the top
of the frame.
7. Remove the two screws and small washers securing the actuator switch sensor to the
elevate actuator.
Pronto® Series
Frame Bracket
Walking Beam
94
Locknut
SureStep Spring
Hook
Part No. 1125075