Adjusting The Seat Position - Invacare Pronto M50 Service Manual

4. Install the accessories, if necessary. Refer to Accessories on page 128.
Accessory Tube
Hex Screws
Locknuts

Adjusting the Seat Position

NOTE: For this procedure, refer to FIGURE 7.6 on page 66.
NOTE: The seat is shipped from the factory in the standard position. The seat can be moved 1-inch
forward or 1-inch rearward. See Detail "A").
1. Remove the four mounting screws, washers and locknuts securing the seat frame plate
and 1-inch adjustment spacers* to the seat pivot.
*NOTE: M61 wheelchairs may have up to two sets of 1-inch adjustment spacers between the seat
frame plate and the seat pivot.
2. Reposition the seat frame plate, 1-inch adjustment spacers* and seat pivot to align the
mounting holes with the desired seat adjustment position (Detail "A").
3. Secure the seat frame plate and 1-inch adjustment spacers* to the seat pivot using the
four mounting screws, washers and locknuts. Torque to 13 ft-lbs ± 20%.
Part No. 1125075
Seat Frame
FIGURE 7.5 Removing/Installing the Seat Frame
Seat Frame Plate
65
SECTION 7—ASBA SEAT
Pronto® Series