4. Using the two socket bolts, spacers and locknuts, secure the telescoping front rigging
support to the seat frame.
5. If necessary, repeat STEPS 2-4 on remaining telescoping front rigging support.
6. Reinstall the seat assembly. Refer to Removing/Installing the Seat Assembly on
page 50.
Seat
FRONT RIGGING
MODEL
PHW93
PH904A and PHAL4A
FIGURE 8.6 Adjusting/Replacing Telescoping Front Rigging Supports
ASBA Seat
NOTE: For this procedure, refer to FIGURE 8.7 on page 78.
1. Remove the two mounting screws, spacers and locknuts that secure the telescoping
front rigging support to the seat frame.
2. Perform one of the following:
• Slide existing telescoping front rigging support to one of three depth positions.
• Remove existing telescoping front rigging.
Part No. 1125075
SECTION 8—FRONT RIGGINGS/FOOTBOARD
Locknuts
Spacers
Inner
Mounting
Holes
STANDARD
POSITION
Holes
4 and 5
Holes
3 and 4
77
Mounting
Bolts
Telescoping Front
Rigging Support
8
6
7
5
3
Not Used
4
2
Mounting Holes
1 INCH OUT
Holes
5 and 6
Holes
4 and 5
Hinge
Pins
2 INCHES OUT
Holes
6 and 7
Holes
5 and 6
Pronto® Series