SECTION 8—FRONT RIGGINGS/FOOTBOARD
Removing
1. Push the front rigging release lever
inward and rotate the footrest outward.
2. Lift up on front rigging and remove
from the wheelchair.
3. Repeat STEPS 1-2 for opposite side of
wheelchair.
Adjusting Footrest Height
Model PHWH93 Front Riggings
NOTE: For this procedure, refer to FIGURE 8.2.
1. Remove any accessory from the front rigging(s).
2. Remove the front rigging from the wheelchair. Refer to Installing/Removing Front
Riggings on page 73.
NOTE: Lay front rigging on a flat surface to simplify procedure.
3. Remove the hex bolt, coved washers and locknut that secure the lower footrest to the
footrest support.
4. Reposition the lower footrest to the
desired height.
5. Reinstall hex bolt, coved washers and
locknut that secure lower footrest to
footrest support. Tighten securely.
6. Repeat STEPS 1-5 for the opposite side
of the wheelchair footrest, if necessary.
7. Reinstall the footrest(s) onto the
wheelchair. Refer to Installing/
Removing Front Riggings on page 73.
Pronto® Series
Telescoping Front Rigging Support
Hinge
Pins
Front Rigging
Front
Release Lever
Rigging
Hinge
Plate
FIGURE 8.1 Installing/Removing Front
Locknut
Coved
Washer
FIGURE 8.2 Model PHWH93 Front
74
Riggings
Footrest Support
Coved Washer
Hex Bolt
Lower
Footrest
Riggings
Part No. 1125075