Section 9-Shrouds And Frame; Removing/Installing The Top Shroud; Removing; Installing - Invacare Pronto M41 Service Manual

SECTION 9—SHROUDS AND FRAME
After any adjustments, repair or service and before use, make sure that all attaching
hardware is tightened securely - otherwise injury or damage may result.
Before performing any maintenance, adjustment or service verify that On/Off
switch on the joystick is in the Off position.
To prevent cracking the plastic shroud material, DO NOT overtighten the
mounting screws.

Removing/Installing the Top Shroud

NOTE: For this procedure, refer to FIGURE 9.1 on page 56.

Removing

1. Disconnect the joystick. Refer to Disconnecting/Connecting the Joystick on page 72.
2. Remove the seat assembly. Refer to Removing/Installing the Seat Assembly on
page 37.
3. Remove the two screws that secure the top shroud to the frame.
4. Remove the two screws that secure both the top and front shrouds to the frame.
5. Remove the top shroud by pulling the top shroud forward then up in order to clear
the motor release levers and seat post.

Installing

1. Pull joystick cable through the center hole in the top shroud.
2. Place the top shroud on the base frame.
NOTE: Pull the shroud forward to clear the motor release levers.
3. Install the two screws that secure the top shroud to the frame. DO NOT overtighten.
4. Attach the front shroud to the top shroud.
5. Install the two screws that secure both the top and front shrouds to the frame. DO
NOT overtighten.
6. Install the seat assembly. Refer to Removing/Installing the Seat Assembly on page 37.
7. Connect the joystick. Refer to Disconnecting/Connecting the Joystick on page 72.
Part No 1145724
SECTION 9—SHROUDS AND FRAME
WARNING
55 ®
Pronto M41