M50/M51 Wheelchairs Manufactured After 8/14/05 And All M61 Wheelchairs; Using The Joystick To Drive The Wheelchair - Invacare Pronto M50 Service Manual

M50/M51 Wheelchairs Manufactured After 8/14/05 and all M61
Wheelchairs
NOTE: For this procedure, refer to FIGURE 4.2.
1. Turn the power On by pressing the
On/Off button.
NOTE: After turning power On, the battery
gauge indicators will light briefly. One of the
following will occur after that:
• The current battery charge will be indicated
on the information gauge display.
• Lock Mode will be indicated by all LEDs
flashing briefly and the information gauge
LEDs chasing slowly from right to left. If
this occurs, press the horn button two times
within ten seconds to unlock the joystick.
2. Turning the power Off by pressing the
On/Off button.
NOTE: If the joystick has been programmed for lock mode, holding the On/Off button down for
four seconds will lock the joystick. The LEDs will flash briefly and the horn will sound a short beep.

Using the Joystick to Drive the Wheelchair

DO NOT operate wheelchair on an incline while in an elevated position. Otherwise,
the wheelchair may tip over and injury or damage may occur.
NOTE: For this procedure, refer to FIGURE 4.3 on page 34.
The joystick provides smooth control of speed and direction. It is equipped with 360
degrees of mobility for ease of operation. The joystick is spring-loaded, and automatically
returns to the upright (neutral) position when released. Pushing the joystick in a given
direction causes the chair to move in that direction.
The joystick has proportional control, meaning that the further it is pushed from the
upright (neutral) position, the faster the wheelchair moves or the seat elevates/lowers.
The maximum speed, however, is limited by the speed setting.
To slow the wheelchair to a stop, simply release the joystick. The wheelchair has
automatic speed and direction compensation to minimize corrections.
Part No. 1125075
SECTION 4—WHEELCHAIR OPERATION
NOTE: SPJ+ w/ACC joystick shown. SPJ+
joystick works the same way.
FIGURE 4.2 Turning the Power On/Off -
M50/M51 Wheelchairs Manufactured After
8/14/05 and all M61 Wheelchairs
WARNING
33
Information
Gauge Display
On/Off
Button
Pronto® Series