Removing/Installing The Back Upholstery; Removing/Installing/Changing The Back Cane Height; Removing - Invacare Pronto M50 Service Manual

Seat Positioning Strap
Quick Release Pin Tab
FIGURE 7.7 Removing/Installing the Seat Positioning Strap

Removing/Installing the Back Upholstery

NOTE: The back canes MUST be removed when removing/installing the back upholstery. Refer to
Removing/Installing/Changing the Back Cane Height on page 67.

Removing/Installing/Changing the Back Cane Height

NOTE: For this procedure, refer to FIGURE 7.8 on page 70.
NOTE: If changing the back height, new back upholstery may be needed as well. Refer to the
following chart to determine if new back upholstery is needed:
If back height required is within the range of the original back upholstery
height, only new back canes will be needed.
If the back height required is NOT within the range of the original back uphol-
stery height, new back upholstery, and back canes will be required
NOTE: Existing hardware and inserts will be reused.
NOTE: Take note of position and orientation of mounting hardware for reinstallation.

Removing

1. Remove flip back armrest from the wheelchair. Refer to Removing/Installing Flip Back
Armrest on page 47.
NOTE: Note the back angle before disassembly for proper reinstallation.
Part No. 1125075
Mounting
Screw
Rear of Seat
Frame
Seat Rail
NOTE
Spacer
Locknut
67
SECTION 7—ASBA SEAT
Seat Pan
Front of Seat
Frame
BACK UPHOLSTERY
HEIGHT
16 to 17 inches
18 to 19 Inches
20 inches
21 to 22 inches
Pronto® Series