SECTION 8—FRONT RIGGINGS/FOOTBOARD
3. Secure telescoping front rigging at desired depth with existing two mounting screws,
spacers, and locknuts. Securely tighten.
NOTE: The two telescoping front rigging supports can be positioned at different depths.
Spacer
Locknut
Seat
Frame
FIGURE 8.7 Adjusting/Replacing Telescoping Front Rigging Supports
Removing/Installing the Footboard Assembly
Pinch point may occur when rotating the footboard assembly.
NOTE: For this procedure, refer to FIGURE 8.8 on page 79.
Removing
1. Remove the quick release pin that secures the footboard assembly to the wheelchair
frame by depressing the button while sliding the pin out.
2. Remove the footboard assembly from the wheelchair frame.
Pronto® Series
Mounting
Screws
Spacer
Locknut
WARNING
78
Depth Mounting
Telescoping Front
Positions
Rigging Support
Depth Mounting
Positions
Part No. 1125075