Section 9-Shrouds/Frame; Removing/Installing The Shrouds - Invacare Pronto M91 Service Manual

SECTION 9—SHROUDS/FRAME
After ANY adjustments, repair or service and BEFORE use, make sure all attaching
hardware is tightened securely - otherwise injury or damage may result.
Before performing any maintenance, adjustment or service verify that ON/OFF
switch on the joystick is in the OFF position.

Removing/Installing the Shrouds

NOTE: For this procedure, refer to FIGURE 9.1.
To prevent cracking the plastic shroud material, DO NOT overtighten the mount-
ing screws.
NOTE: Reverse this procedure to install the shrouds.
1. Disconnect the joystick. Refer to Disconnecting/Connecting the Joystick on page 92.
2. Remove or tilt the seat assembly. Refer to Removing/Installing or Tilting the Seat
Assembly on page 30.
3. Perform one (1) of the following:
• Top Shroud - Lift up on rear edge of top shroud to release the four (4) hook and
loop strips that secure the top shroud to the base frame.
• Right and Left Side Shroud -
i. Remove the drive wheel. Refer to Removing/Installing the Drive Wheel on
page 67.
ii. Remove the five (5) mounting screws that secure the shroud to the side frame
assembly and remove side shroud from side frame.
NOTE: Shorter mounting screws are used to secure the top rear of side shrouds (Detail "A" of
FIGURE 9.1).
• Shroud Plate - Remove the two (2) mounting screws and washers securing the
shroud plate to the side frame assembly (Detail "A" of FIGURE 9.1) and remove
shroud plate from side frame.
• Front Shroud - Remove the two (2) mounting screws that secure the front shroud
to the base frame (Detail "B" of FIGURE 9.1) and remove front shroud from the
base frame.
Part No. 1125038
SECTION 9—SHROUDS/FRAME
WARNING
WARNING
71 ® ™
Pronto M91 and M94