Section 8-Shrouds/Frame; Removing/Installing The Shrouds - Invacare Pronto M71 Service Manual

SECTION 8—SHROUDS/FRAME
SECTION 8—SHROUDS/FRAME
After ANY adjustments, repair or service and BEFORE use, make sure all attaching
hardware is tightened securely - otherwise injury or damage may result.
Before performing any maintenance, adjustment or service verify that ON/OFF
switch on the joystick is in the OFF position.

Removing/Installing the Shrouds

NOTE: For this procedure, refer to FIGURE 8.1 on page 75.
To prevent cracking the plastic shroud material, DO NOT overtighten the
mounting screws.
NOTE: Reverse this procedure to install the shrouds.
1. Disconnect the joystick. Refer to Disconnecting/Connecting the Joystick on page 97.
2. Remove the seat assembly. Refer to Removing/Installing the Seat Assembly on
page 30.
3. Perform one of the following:
A. Right and Left Side Shroud - Remove the five mounting screws that secure the
shroud to the side frame assembly.
NOTE: Shorter mounting screws are used to secure the top rear of side shrouds (Detail "A" of
FIGURE 8.1).
B. Shroud Plate - Remove the two mounting screws and washers securing the shroud
plate to the side frame assembly (Detail "A" of FIGURE 8.1).
C. Front Shroud - Remove the two mounting screws that secure the front shroud to
the base frame (Detail "B" of FIGURE 8.1).
D. Rear Shroud - Perform one of the following:
i. BEFORE 7/14/03 - Rotate knob 90° and remove rear shroud from base frame
(Detail "B" of FIGURE 8.1).
ii. AFTER 7/14/03 - Remove the two mounting screws securing the rear shroud to
the base frame and remove rear shroud from base frame (Detail "C" of
FIGURE 8.1).
Pronto® M71™
All manuals and user guides at all-guides.com
WARNING
WARNING
74
Part No 1118377