Removing/Installing Flip Back Armrest - Invacare Pronto M50 Service Manual

Removing/Installing Flip Back Armrest

Make sure the flip back armrest release levers and height adjustment levers are in
the locked position before using the wheelchair.
NOTE: For this procedure, refer to FIGURE 5.4.
NOTE: Flip back armrest release lever MUST be in unlocked position when placing armrest into
the arm sockets.
NOTE: Reverse this procedure to install the flip back armrest.
1. If necessary, disconnect the joystick. Disconnecting/Connecting the Joystick on
page 123.
2. Unlock flip back armrest by pulling flip back armrest release lever into the unlocked
(horizontal) position.
3. Remove quick release pin securing the flip back armrest to the wheelchair frame.
4. Pull up on the flip back armrest and remove the armrest from the arm sockets.
5. Repeat STEPS 1-4 for the opposite flip back armrest, if necessary.
Flip Back Armrest
Rear Arm Socket
FIGURE 5.4 Removing/Installing Flip Back Armrest
Part No. 1125075
WARNING
Quick Release Pin
Flip Back Armrest Release Lever
Front Arm Socket
47
SECTION 5—ARMS
Locked
(Vertical)
Unlocked
(Horizontal)
Seat Frame
Pronto® Series