Section 9-Wheels; Replacing The Front/Rear Casters - Invacare Pronto M50 Service Manual

SECTION 9—WHEELS
After ANY adjustments, repair or service and before use, make sure all attaching
hardware is tightened securely - otherwise injury or damage may result.
Before performing any maintenance, adjustment or service verify that On/Off
switch on the joystick is in the Off position.

Replacing the Front/Rear Casters

NOTE: For this procedure, refer to FIGURE 9.1.
NOTE: Front and rear casters are replaced in the same manner.
NOTE: When replacing the front/rear casters, it is necessary to brace the caster to prevent
spinning.
1. Remove the mounting screw, two washers and locknut that secures the caster to the
fork.
2. Remove the caster and discard.
3. Secure new caster to fork with existing mounting screw, two washers and locknut.
Securely tighten.
Part No. 1125075
WARNING
Fork
Mounting Screw
Washer
FIGURE 9.1 Replacing the Front/Rear Casters
Locknut
Washer
Caster
81
SECTION 9—WHEELS
Pronto® Series