Repositioning The Joystick Mounting Bracket; Van Seat - Invacare Pronto M50 Service Manual

Standard
Arm
DETAIL "A" - TIE-WRAP
LOCATIONS
Office Style Seat
Tie-Wrap Here

Repositioning the Joystick Mounting Bracket

Van Seat

NOTE: For this procedure, refer to FIGURE 13.2 on page 122.
NOTE: Take note of position and orientation of mounting hardware for reinstalling the joystick
assembly.
1. Turn the adjustment lock lever to release the joystick mounting tube from the
mounting bracket.
2. Remove the joystick from the wheelchair.
3. Remove the three hex mounting screws, spacers and locknuts that secure the
mounting bracket to the three mounting holes on the arm frame.
NOTE: The mounting bracket is mounted to the inside of the arm frame.
4. Reposition the mounting bracket on the opposite arm frame.
Part No. 1125075
Office Style Seat
Mounting Bracket and
Adjustment Lock Lever
Standard
Joystick Cable
FIGURE 13.1 Removing/Installing the Joystick
SECTION 13—ELECTRONICS
Joystick
Mounting
Arm
Tie-Wrap Here
121
Joystick
Tube
Mounting
Screws
Joystick
Pronto® Series