Section 9 - Electronics; Preparing Mk5 Joystick For Use; Repositioning Mk5 Joystick - Invacare TDX Series Owner's Manual

All manuals and user guides at all-guides.com
ELECTRONICS
This Section Includes the Following:
Preparing Joystick for Use
After ANY adjustments, repair or service and BEFORE use, make sure all
attaching hardware is tightened securely - otherwise injury or damage
may result.
PREPARING JOYSTICK FOR USE (FIGURE 1)
NOTE: The joystick is factory installed on the right side of the wheelchair. To reposition the joystick
onto the left side of the wheelchair refer to REPOSITIONING JOYSTICK in this procedure of the
manual. The joystick should be repositioned by a qualified technician.
1. Turn the adjustment lock lever to release the joystick mounting tube from the
mounting bracket.
2. Slide joystick mounting tube to the desired position.
3. Turn the adjustment lock lever to secure the joystick mounting tube in the mounting
bracket.
Mounting Bracket
Joystick Mounting Tube
Adjustment Lock Lever
FIGURE 1 - PREPARING JOYSTICK FOR USE
REPOSITIONING JOYSTICK (FIGURE 2)
1. Turn the adjustment lock lever to release the joystick mounting tube from the
mounting bracket.
2. Remove the joystick from the wheelchair.
3. Remove the three (3) hex screws that secure the both halves of the mounting
bracket to the arm tube.
4. Reposition mounting bracket on opposite arm tube ensuring the threaded plate of
the mounting bracket is on the inside of the arm tube as shown in FIGURE 2.
5. Using the three hex mounting screws and washers, secure both halves of the mount-
ing bracket to the arm tube.
6. Slide the joystick mounting tube through the mounting bracket to the desired posi-
tion.
7. Turn the adjustment lock lever to secure the joystick mounting tube into the
mounting bracket.
Part No. 1114809
Repositioning Joystick
WARNING
69
SECTION 9
NOTE: MK5 DPJ joystick
shown, MK5 MPJ and SPJ-
80 joysticks adjust the
same.
TDX WHEELCHAIRS