Touch Panel Sensitivity - Firstech CM7000 Master Manual

Alarm and starter

Hide thumbs Also See for CM7000:

Master manual (67 pages)

Table Of Contents

Table of Contents

CM7000 Master Guide

RPS Touch and car call functions do not require programming, however in order to unlock/disarm your

vehicle you must program a 4 digit passcode (numbers 1 through 10 only) you can view our video library

for programming instructions at: techfeed.compustar.com

Programming Your Code

STEP 1: Choose your RPS Touch 4 digit code. '0' is not available.

STEP 2: Turn ignition to the 'ON' position and leave driver's door open.

STEP 3: Hold your finger over the 'Red Circle' icon for 3 seconds.

STEP 4: When the siren chirps and LEDs flash in a circular pattern, tap on your first number. (Hold the

number for 2.5 seconds to choose 6 through 10.) After choosing your first number you will

get one siren chirp and LEDs will flash in a circular pattern.

STEP 5: Repeat Step 4 until all four digits are set. You will get 1 siren chirp and 1 parking light flash.

Repeat Steps 2 - 5 if you get 3 chirps and light flashes. Your RPS Touch is now programmed.

Alarm rearm and lock

To rearm hold your finger on the 'Red Circle' for 3 seconds.

Alarm disarm and unlock

To disarm hold your finger over the 'Red Circle' for 3 seconds. Once the LEDs start their circular pattern,

enter your 4 digit code by touching the window with the flat part of the tip of any finger over the number

for each digit of your code. (Refer to Step 4 above or training video at techfeed.compustar.com) Two

seconds after entering the 4th digit, your system will first re-arm/lock. In two seconds, it will disarm/

unlock.

2 Way LCD remote paging

To page a 2 Way LCD remote just tap the 'Red Circle' twice.