Firstech CM7000 Master Manual page 23

CM7000 Master Guide
Pin 2 Black/White – thermister: temp resistance input.
Connector 9 (CN9), 4-Pin to 4-Pin or 6-Pin (Pre-wired Antenna Cable)
Connect your antenna cable to this port. You can only use 4 to 4 pin or 4 to 6 pin antenna cables. 6 to 6
Pin antenna cables do not work. Do not use both Connector 9 and Connector 10 at the same time.
Pin 1 Yellow - RX input. This wire receives the signal from remote.
Pin 2 White - TX output. This wire transmits the signal to remote.
Pin 3 Red - Constant 12V positive (+) output.
Pin 4 Black - Ground
Connector 10 (CN10), 6-Pin to 6-Pin (Pre-wired Antenna Cable)
Connect your antenna cable to this port. You can only use 6 to 6 pin antenna cables. 4 to 4 or 4 to 6 Pin
antenna cables do not work. Do not use both Connector 9 and Connector 10 at the same time.
Pin 1 Red - Constant 12V positive (+) output.
Pin 2 White - TX output. This wire transmits the signal to remote.
Pin 3 Orange - Constant 5V output
Pin 4 Yellow - RX input. This wire receives the signal from remote.
Pin 5 Black – Negative (-) ground.
Pin 6 Blue - RX/TX control
Connector 11 (CN11), 6-Pin
Note: This harness is no longer included with CM7 wire harness kits. The Lock (POC
3), Unlock (POC 4), Trunk (POC 7) release outputs have been moved to CN5 (Grey 20
pin accessory harness) and are now programmable outputs. This connector will still be
available for any Firstech lock harness. (FT-DM600 or FT-DM700)
Pin 1 None - 12v B+ constant output: available when using a Firstech door lock Module DM600, DM700
Pin 2 Violet/White - Trunk release 250mA negative (-) output: This is an optional output that will release
the trunk. Use CN1, Pin 2 if the vehicle is equipped with a (+) trunk release. System will unlock doors
and disarm alarm prior to trunk release.
Copyright 2014 Firstech, LLC.
Alarm and Starter System
techfeed.compustar.com
Page 23