Firstech CM7000 Master Manual page 31

CM7000 Master Guide
1-09 Ignition Controlled Locks: When FO 2-4 are selected, the user can activate the "drive lock" or ignition
controlled door locking feature using a Firstech remote or Drone. (Please check specific remote
user's manual for steps to activate Drive lock.)
FO1 - Off: (default)
FO2 - On: This option (when activated with the Firstech remote or Drone) will provide a door lock
output when the foot brake is applied or 12 Volts is applied to the foot brake input on the CM7. The
CM7 will also provide a door unlock output as soon as the key is turned off or 12v ignition is removed
from the CM7.
FO3 - RPM locking: (Tach input is required for this option to operate properly.) This
option will provide a door lock output at approximately 20% RPM over the programmed idle tach
output. (i.e. program tach at 1000 rpm and doors will lock at a sustained 1200 rpm when moving.)
The CM7 will also provide a door unlock output as soon as the key is turned off or 12v ignition is
removed from the CM7.
1-10 Auto Relock:
FO1 - Off: (default)
FO2 - 30 seconds: This option allows the CM7 to automatically relock/rearm 30 seconds after
CM7 has been disarmed/unlocked. This will only happen if no zones have not been opened.
FO3 - 60 seconds: This option allows the CM7 to automatically relock/rearm 60 seconds after
CM7 has been disarmed/unlocked. This will only happen if no zones have not been opened.
FO4 - 5 minutes: This option allows the CM7 to automatically relock/rearm 5 minutes after it has
been disarmed/unlocked. This will only happen if no zones have not been opened.
1-11 Ignition / Accessory Upon Unlock:
FO1 - Off: (default)
FO2 - Ignition (+) and (-) pulse output with disarm: This option will pulse both (+) and
(-) ignition wires upon unlock/disarm. Most new Ford vehicles require ignition pulsed +
immobilizer with unlock to disarm the factory alarm.
FO3 - Accessory (+) and (-) pulse output with disarm: This option will pulse both (+) and
(-) accessory wires upon unlock/disarm.
FO4 - Ignition (+) and (-) pulse and Accessory (+) and (-) pulse output with disarm:
This option will pulse both (+) and (-) ignition and accessory wires upon unlock/disarm. Some new
Ford vehicles require ignition and accessory pulsed + immobilizer with unlock to
disarm the factory alarm. Important: Also used in cases where the vehicle's radio may turn on
and stay on until the door is opened when accessory is pulsed.
1-12 OEM Remote Arm/Disarm Update for 2 Way Firstech Remotes: This feature disables the arming,
disarming, and remote start confirmation updates to any Firstech 2 Way LCD when using an OEM
remote.
FO1 - On: (default)
FO2 - Off: This feature disables the page back update to the 2 Way Firstech remote when your
interface module provides OEM remote status updates to the CM7.
Copyright 2014 Firstech, LLC.
Alarm and Starter System
techfeed.compustar.com
Page 31