Frequently Asked Questions - Firstech CM7000 Master Manual

CM7000 Master Guide
Parking Light
Alarm LED Diagnostics
When the alarm is triggered the LED on the RPS (if installed), Secure Valet (if installed) and the LED (if
installed) will flash a certain amount of times as shown in the table below. This is intended for users with 1
Way remotes.
Priority

Frequently Asked Questions

I have everything hooked up and the system will not respond.
A: The remotes need to be programmed. Review the "Common Procedure" section of this manual.
When remote starting, the siren chirps 3 times and parking lights flash 3 then 1 time.
A: You must program tach before remote starting. Also be sure to check the foot brake and ignition wires on
the CM7000 and CM7200.
I am trying to program the control module with the OP500 Option Programmer and it flashes
"ER 01" when I plug it in to the antenna cable. What should I do?
A: Make sure that the system is not locked/armed. The last thing to check is the antenna cable or antenna
extension cable – make sure this is not damaged. If you need to, try another cable. When the OP500
is working properly, it will read "success good." You no longer need to program the remotes before the
OP500 will sync.
What is the green/white wire loop inside the brain module?
A: This wire determines the transmission mode. With the loop intact, the system is set for manual
transmissions. With the loop cut, the system is set for automatic transmission.
Copyright 2014 Firstech, LLC.
Number of
Flashes
1 Lost engine sensing signal (Tach/Alternator/Tachless)
2 Lost emergency brake signal (Manual Transmission)
3 Foot brake triggered
4 Hood pin triggered
Trigger
1 Door/Hood/Trunk/Ign Triggered
2 2nd Shock Triggered
3 2nd Auxiliary Input Triggered
4 Panic with remote
Remote Start Shutdown Error
LED Flash Diagnostic
2 flashes, break, then repeat
3 flashes, break, then repeat
4 flashes, break, then repeat
5 flashes, break, then repeat
Alarm and Starter System
techfeed.compustar.com
Page 53