Firstech CM7000 Master Manual page 30

CM7000 Master Guide
1-06 Reservation Lock: Optional manual transmission reservation mode procedures.
FO1 - Locks before set: (default) this option will lock the doors before the vehicle engine shuts
down to complete reservation mode. This procedure is much safer ensuring that the vehicle cannot be
shifted into gear after the engine shuts down and before or during the door locking procedure.
FO2 - Activate reservation mode using RF remote: This procedure is designed to give
the user more control over when reservation mode is initiated. (Default is any time the e-brake
is set reservation mode will engage). Once the e-brake is set the user must hold the start button
on the remote for 2.5 seconds before reservation mode will engage. Once engaged, reservation
mode will operate normally. Note: this procedure is strongly recommended for manual
transmission Push To Start (PTS) vehicles.
FO3 - Reservation sets 10 seconds after last zone is closed: This option will allow the user
to open any zone (that is connected to the CM7) within 10 seconds and extend the reservation mode
procedure time until 10 seconds after all zones are closed. If the user wishes to complete reservation
mode before the 10 second window is up they can arm or lock the CM7 using any means available.
Note: this is the only reservation mode option that will allow the user to complete
reservation mode using the arm/lock command. All other options will cancel
reservation mode with the arm/lock command.
FO4 - N/A: Hidden option please contact Firstech technical support for more information at 888-
820-3690 ext. 203
1-07 Unlock / Disarm with Trunk Release:
FO1 - Unlock, Factory Alarm Disarm (FAD) trunk release: This option will send unlock
and FAD outputs prior to sending the Trunk release output. This applies to analog and data to data
situations.
FO2 - Factory Alarm Disarm (FAD) with trunk release: This option will send the FAD output
prior to sending the trunk release output. This applies to analog and data to data situations.
FO3 - Trunk release only: This option will only send the trunk release output when triggered. This
applies to analog and data to data situations.
1-08 Passive Mode: When options 2 or 3 are selected the user has the choice to activate "Passive" feature
using a Firstech remote or Drone (please check specific remote user's manual for steps to
activate passive)
FO1 - Off: (default)
FO2 - Passive locking with passive arming: This option, when passive is activated will send
lock/arm outputs to lock/arm the CM7 30 seconds after the last zone is closed. The CM7 will flash
the parking lights and chirp the siren 1 time every 10 seconds 3 times total as a warning that it is
going to Arm/lock itself.
FO3 - No lock output with Passive arm: This option, when passive arm feature is activated,
will NOT send the lock command one the CM7 has passively armed itself. The CM7 will flash the
parking lights and chirp the siren 1 time every 10 seconds 3 times total as a warning that it is going to
arm itself.
Copyright 2014 Firstech, LLC.
Alarm and Starter System
techfeed.compustar.com
Page 30