Wiring Descriptions - Firstech CM7000 Master Manual

CM7000 Master Guide
The CM7 Series Blade connector has a locking tab. Non-locking tab blade harnesses will work
but you MUST TAKE CARE TO NOT PLUG THE HARNESS IN UPSIDE DOWN. Make sure the two
notches on the top of the harness face the top (CM and barcode sticker side) of the brain. When looking at
the wire side of the harness the two notches must be at the top of the plug.
Blade system includes:
1. Blade-AL or Blade-TB (NOTE: These modules are blank and must be flashed on your computer.)
2. 20 Pin locking wiring harness
3. 3 Pin harness used in some installs
IMPORTANT: Install diagrams are not included and must be downloaded from compustar.idatalink.com
when flashing the Blade you can use the Y-Cable OP500 (gold tag) end and not CM4 Series (silver tag)
end. ADS and Firstech recommends using the 4 pin RS232 cable to avoid confusion. Cartridge must be
removed to if the CM7 is being updated with a Firstech updater program from techfeed.compustar.com
WARNING: Manufacturer or seller assumes no responsibility for any injuries and/or damages caused by
improper care of the product such as decomposition, conversion, and transform done by a user voluntarily.
WARNING: There should be no wiring routed around any pedals which can cause a driving hazard.

Wiring Descriptions

Connector 1 (CN1), 8-Pin
Pin 1 Red - Constant 12V positive (+) power input. This wire must be connected. The proper wire
will test (+) 12V at all times, even when the key is in the off position, on position, and during crank.
Pin 2 Green/White - Programmable Output: This positive (+) parking light wire triggers
when you lock, unlock, remote start, or during troubleshooting diagnostics. Note: This output is
programmable and can provide a 2nd starter or (+) trunk release output. This is
achieved using Jumpers located under the access door on top of the control module.
Pin 3 Red/White - Constant 12V positive (+) power input. This wire must be connected it provides power
for the accessory and starter output. The proper vehicle wire will test (+) 12V at all times - while the
key is in the off position, the on position and during crank.
Pin 4 White - Programmable Output: Accessory 12V positive (+) output. This wire must be connected
to the vehicle accessory / HVAC blower motor wire. The proper wire will test 0V with the key in the off
position, (+) 12V while key is in the on position, 0V while cranking and back to (+) 12V when the key
is returned to the on position. Note: This output is programmable and provides a (+) 2nd
ignition or (+) 2nd Starter using the jumpers located under the access door on top
of the control module.
Copyright 2014 Firstech, LLC.
Alarm and Starter System
techfeed.compustar.com
Page 17