Firstech CM7000 Master Manual page 38

CM7000 Master Guide
3-03 Dome Light Delay: This option is used when connecting the door trigger input to the vehicles dome
light circuit. It delays the door trigger input to prevent the door open icon displaying on 2 Way
remotes upon lock/arm.
FO1- Off: (default)
FO2 - 5 seconds: This option will delay the door trigger input for 5 seconds when arming the
system to account for any vehicle dome light output delay.
FO3 - 45 seconds: This option will delay the door trigger input for 45 seconds when arming the
system to account for any vehicle dome light output delay.
FO4 - Auto: This option will allow the CM7 to wait for a change in polarity on the door input circuit,
after the system has been armed, to monitor for security.
3-04 Starter-Kill: This option determines the operation of the GWA wire (POC 1 CN4 Pin 1 Blue/white)
FO1 - Anti grind + Starter interrupt: this option will allow for POC 1 to provide a negative
output when the system is armed or remote started. This will enable a starter interrupt to prevent the
vehicle from being started with the key when in an armed state.
FO2 - Anti Grind only: This option will allow POC 1 to provide a negative output when the system
is armed. This will enable starter interrupt and prevent the user from grinding the starter during the
takeover procedure.
FO3 - Anti Grind and passive starter interrupt: This option will allow for POC 1 to provide a
negative output when the system is remote started or the passive starter interrupt is engaged. This will
prevent the user from grinding the starter during the takeover procedure and enable starter interrupt
45 seconds after the ignition has been turned off.
3-05 Anti-Jacking: Note: this feature requires the starter-kill relay to be wired to the ignition vs. the starter
wire. This feature will allow the CM7 to interrupt the ignition wire if panic mode is activated while the
vehicle is running with the key.
FO1 - Off: (default) anti-carjacking feature is not enabled and the starter interrupt will operate based
on feature 3-04 option setting.
FO2 - On: this option will enable the anti-carjacking feature. Make sure the starter interrupt relay
is wired to interrupt the vehicle's ignition wire so the feature will operate as described. While the
vehicle is running with the key and the panic mode is activated using any Firstech 4 button or 2 way
LCD remote, the CM7 will enable the ignition interrupt relay so the vehicle cannot be re-started.
Note: When using ignition-kill on manual transmission vehicles feature 3-04 must be set to option
2 will need to be utilized. this disables the anti-grind circuit while the vehicle is remote-started; if the
anti-grind circuit is active and the start-kill relay is installed in the ignition, the relay will "buzz" while
remote-started.
3-06 Factory Alarm Option: This feature will enable or disable the security features of the CM7000, or
CM7200. Security features include sensor inputs, zone inputs (unless using with manual transmission),
horn, and siren output. Basic features will function normally (lock, unlock, trunk release, remote start,
parking lights.)
FO1 - Off: (CM7200 default)/FO1- On: (default CM7000) Depending on the Control Module this
option will enable or disable the security features.
Copyright 2014 Firstech, LLC.
Alarm and Starter System
techfeed.compustar.com
Page 38