Table of Contents
Advertisement
CM7000 Master Guide
Remote Programming Routine
IMPORTANT: Any and all remotes must be coded to the control module prior to performing any and all
operations.
STEP 1: Activate programming mode by manually turning the vehicle's key between the Ign On and Off
(or the Acc & On positions) five times within 10 seconds. The vehicle's parking lights will flash
once with the successful completion of this step. Note: if the foot brake (+ brake input) is
applied during this process your system will enter Valet Mode and the remotes will
not program.
STEP 2: Within a 2 second period after the 5th ignition cycle tap Button I on two way remotes or the Lock
button on one-way remotes for a half second. The parking lights will flash once to confirm the
transmitter has been coded. Repeat for additional remotes, up to four. Note: if you only have
2 remotes please program each remote twice.
Valet Mode
Valet Mode disables all system features except for the keyless entry. Use Valet when servicing or loaning your
vehicle to others to avoid any inconvenience or mishap when operating the vehicle. There are no visual
indicators when the security system is in Valet Mode. There is a parking light indication when remote starting
in Valet Mode. (3 flashes followed by 10 flashes). Also when in Valet Mode, the keyless entry feature will still
operate.
The system can be put into valet mode one of 3 ways:
1. While holding the foot brake (12V+ brake input), cycle the key to the Ignition or 'On' position and then
back to the 'Off' position 5 times within 10 seconds. The parking lights will flash once indicating that the
system has entered Valet Mode.
2. Turn the key to the Ignition or 'On' position then using a 4 button remote press and release the lock and
trunk buttons together simultaneously for a half second. The vehicle parking lights will flash 1 time to
indicate the system has successfully entered valet mode.
Copyright 2014 Firstech, LLC.
Exiting Programming: Programming is a timed sequence. After 2 seconds
the parking lights will flash twice signaling the end of programming mode.
Programming Multiple Remotes: After the confirmation flash given in STEP
2, code additional remotes by tapping Button I on two way remotes or
the Lock button on one way remotes. The parking lights will flash once
confirming each additional remote. This system can recognize up to four
remotes. Note: if you only have 2 remotes please program
each remote twice.
Alarm and Starter System
techfeed.compustar.com
Page 6
Hide quick links:
Advertisement
Table of Contents
