Rps Touch (Remote Paging Sensor) - Firstech Compustar RF-2W9000FM User Manual

Advanced System Functions

RPS Touch (Remote Paging Sensor)

The new RPS touch has multiple features including: remote paging, 4 digit pin unlock/disarm, and arm/lock. All features are operated with a simple
touch of the sensor.
Please have your installer program Option 3-16 to Setting 2.
RPS Touch and car call functions do not require programming, however in order to unlock/disarm your vehicle you must program a 4 digit passcode
using the instructions below:
STEP 1:Choose your RPS Touch 4 digit code. '0' is not available.
STEP 2: Turn ignition to the 'ON' position and leave driver's door open.
STEP 3: Hold your finger over the 'Red Circle' icon for 2.5 seconds.
STEP 4: When the siren chirps and LEDs flash in a circular pattern, tap on your first number. (Hold the number for 2.5 seconds to choose 6 through
10.) After choosing your first number you will get one siren chirp and LEDs will flash in a circular pattern.
STEP 5: Repeat Step 4 until all four digits are set. You will get 1 siren chirp and 1 parking light flash. Repeat Steps 2 - 5 if you get 3 chirps and light
flashes. Your RPS Touch is now programmed.
Alarm rearm and lock
To rearm hold your finger on the 'Red Circle' for 2.5 seconds.
By Firstech, LLC 28
FT-2WLCD-S-E_UserGuide.indd 29-30
Advanced System Functions
Alarm disarm and unlock
To disarm hold your finger over the 'Red Circle' for 2.5 seconds. Once the LEDs start their circular pattern, enter your 4 digit code. (Refer to Step 4
above.) Two seconds after entering the 4th digit, your system will disarm.
2 Way LCD remote paging
To page a 2 Way LCD remote just tap the 'Red Circle' twice.
Touch Panel Sensitivity
To change touch sensitivity open the driver's door, hold the button on the back of the RPS Touch until the LEDs go out. Release button and tap again.
The number of solid LEDs represent sensitivity of touch, 1 being the lowest, 5 the highest.
29 By Firstech, LLC
2011-6-10 12:05:46