Firstech CM7000 Master Manual page 41

CM7000 Master Guide
3-14 Defrost output Timing: This feature controls the output timing of POC setting 17, defrost. Note:
POC setting 21 defrost 2 is has a fixed pulsed output and is NOT affected by this
feature.
FO1 - 500mS Pulse: This option will provide a 500 Millisecond pulsed output on any POC
programmed with setting 17 (Defrost) with timing based off of feature 3-12 option setting.
FO2 - 3 minute latched: This option will provide a 3 minute latched output on any POC
programmed with setting 17 (Defrost) with timing based off of feature 3-12 option setting. (This would
be good for any rear view mirror defrost that may need a short latched output time.)
FO3 - 7 minute latched: This option will provide a 7 minute latched output on any POC
programmed with setting 17 (Defrost) with timing based off of feature 3-12 option settings. (This
would be good for many front, rear, or rear view mirror defrost functions that may need a longer
latched output time.)
FO4 - Latched for entire runtime: (Remote start runtime based off of feature 2-07 option
setting) This feature will provide a latched output for the entire remote start runtime on any POC
programmed with setting 17 (defrost) with timing based off of feature 3-12 option settings. Caution:
make sure not to latch rear defrost functions on for too long as it may cause damage to the heating
elements in the window.
3-15 Soft Disarm: this feature will enable Factory Alarm Arm (FAA) and Factory Alarm Disarm (FAD)
outputs to trigger when silencing the Compustar siren when sounding with full alarm.
FO1 - Off: (Default) this will keep the standard Compustar soft disarm operation. Soft disarm feature
allows the user to silence the Compustar siren as its sounding with full alarm without fully disarming
the system which may unlock the doors and leave the vehicle unsecure.
FO2 - On: this option will provide a FAD output on both data and analog connections, when the
user taps the unlock/disarm once to silence the Compustar system while it's sounding, so it will disarm
any factory alarm that may be sounding as well. In case the FAD function unlocks the doors the CM7
will send the FAA on both data and analog connections 5 seconds later to make sure the vehicle is
re-locked and secure. (This feature works well with GM, Chrysler, Dodge, Jeep, Toyota, Lexus vehicles
that may have factory security.)
3-16 RPS: (Remote Paging Sensor) this feature sets the RPS hardware being used with the CM7.
FO1 - RPS Touch: (default) this option enables the RPS touch functions when using the RPS touch
hardware with the CM7. RPS can be used to arm/lock and disarm/unlock a CM7 or page a Firstech
remote or accessory. Please refer the RPS section of this manual or the RPS product manual for
installation and operation of the RPS touch hardware.
FO2 - RPS II: (knock sensor) This option enables the RPS II functions when using the RPS II hardware
with the CM7. RPS can be used to arm/lock and disarm/unlock a CM7 or page a Firstech remote or
accessory. Please refer the RPS section of this manual or the RPS product manual for installation and
operation of the RPS II hardware.
Copyright 2014 Firstech, LLC.
Alarm and Starter System
techfeed.compustar.com
Page 41