Fitting The Anchor Rods; Fitting Distribution Tube And Supply/Return Header - Buderus Logano G215 US Installation And Maintenance Instructions Manual

7 Boiler block assembly

7.1.8 Fitting the anchor rods

NOTICE
Insert the anchor rods before removing the
compression tool.
Never remove the compression tool first.
SYSTEM DAMAGE
due to incorrect spring washer assembly.
Ensure that the spring
CAUTION!
washers are arranged opposite each
other on the anchor rods.
Insert the anchor rods with spring washers into the
case cams on the l.h. and r.h. side as well as
adjacent to the lower boiler hubs.
Tighten the nuts on the anchor rod threads by hand.
Tighten the nuts 1 to 1½ turns on the anchor rods.
Release and remove the compression tool.

7.1.9 Fitting distribution tube and supply/return header

The distribution tube, the supply/return header and the
sensor well are already assembled if the boiler block is
supplied as a ready assembled unit.
NOTICE
Before installation of the supply/return
header, first push the distribution tube from
the boiler front into the boiler (don't forget
the boiler hub flat gasket) if insufficient
space is available behind the boiler.
Secure the distribution tube to the supply/return
header with M 8 × 16 screws and flat gasket.
22 Installation and maintenance instructions Logano G215 US oil/gas-fired boilers • Issue 11/2004
1
5
Fig. 17 Fitting the anchor rods – layout of spring washers
1 Anchor rods
2 Nut
3 Spring washers
4 Cast lugs
5 Compression tool
6 Spring washer arrangement
4
3
Fig. 18 Fitting feed pipe on supply/return header
1 supply/return header
2 Flat gasket
3 Distribution tube
4 M 8 × 16 bolts (brass)
We reserve the right to make any changes due to technical modifications.
2 3
4
A
1
2 1