Positioning The Flue Outlet; Sealing Boiler Hubs - Buderus Logano G215 US Installation And Maintenance Instructions Manual

7 Boiler block assembly

7.1.11 Positioning the flue outlet

The flue outlet comes with sealing rope already fitted.
Remove the washers and nuts from the threaded
studs.
Position the flue outlet on both threaded studs on the
back section and secure with nuts.

7.1.12 Sealing boiler hubs

The reducer included with the B-Kit is required for fitting
the boiler fill and drain valve (boiler fill & drain valve).
The boiler fill & drain valve is also a component of the
B-Kit.
Seal with teflon tape or paste the reducer into the
bottom boiler hub at the back of the boiler.
Install the boiler fill & drain valve on the reducer.
Close the top boiler hub on the front section with the
blank flange.
Screw in the plug with the flat gasket into the lower
boiler hub.
24 Installation and maintenance instructions Logano G215 US oil/gas-fired boilers • Issue 11/2004
Fig. 23 Fitting the flue outlet
Fig. 24 Sealing the reducer
1 Reducer
1
Fig. 25 Seal boiler hubs at the front section
1 Blank flange
2 Plug
We reserve the right to make any changes due to technical modifications.
1
2