Table of Contents
Advertisement
Boiler block assembly
7.4.2 Insert the flue gas baffle plates
Remove the corrugated cardboard packaging when
the block is supplied ready assembled.
When the boiler is supplied in sections, remove the
flue gas baffle plates from the carton containing the
small iron fittings.
Install flue gas baffle plates in accordance with the
following table into the central second flue gas pass.
The cast lugs should point towards the center of the
boiler.
Install flue gas baffle plates in accordance with the
following table into the third flue gas pass. The cast
lugs should point outwards.
Boiler section
2. flue gas pass
top
center
bottom
3. flue gas pass
Tab. 12 Arrangement of the flue gas baffle plates
The flue gas temperature can be increased by removing
the flue gas baffle platess (
7.4.3 Installing the burner door
The burner door can be mounted either on the r.h. side
and on the l.h. side. Installation on the r.h. side is
described below.
Screw the two hinge pins to the front section with one
M12 × 35 hexagon bolt each.
We reserve the right to make any changes due to technical modifications.
Installation and maintenance instructions Logano G215 US oil/gas-fired boilers • Issue 11/2004
3
4
5
6
7
–
–
–
–
–
2
–
2
–
–
2
–
2
–
–
2
2
–
–
–
Chapter 9.6.1, page 44).
Fig. 29 flue gas baffle plates into the second flue gas pass
(here: centrally)
Fig. 30 flue gas baffle platesinto the third flue gas pass
Fig. 31 Fit hinge pins (here: on the r.h. side)
1 M12 × 35 hexagon bolt
7
1
1
27
Hide quick links:
Advertisement
Table of Contents
