Table of Contents
Advertisement
5
Boiler block assembly
Front section assembly
Due to the threaded studs, never use the auxiliary flange
at the front of the upper boiler hub when assembling the
front section.
V Push the pull rod together with the compression unit
through the upper boiler hub.
V Carry out all remaining steps as described above
(
Chapter 5.1.7, page 20).
5.1.8
Fitting the anchor rods
Insert the anchor rods [1] before removing
the compression tool [5].
Never remove the compression tool first.
Caution: Risk of system damage due to
incorrect fitting of spring washers.
V Ensure that the spring washers [3] are
facing each other on the anchor rods [1].
V Slot the anchor rods [1] fitted with spring washers [3]
into the cast lugs [4] near the boiler bosses on the right
and left and at the bottom.
V Screw the nuts onto the threads of the anchor rods [1]
by hand.
V Tighten the nuts on the anchor rods 1 to 1½ turns.
V Undo the compression tool [5] and remove.
22
Logano G225/Logano plus GB225 - We reserve the right to make any changes due to technical modifications.
Fig. 16 Fitting the compression tool to the front section
1
5
Fig. 17 Fitting the anchor rods – arrangement of the
dished washers
1
Anchor rods
2
Nut
3
Spring washers
4
Cast lugs
5
Compression tool
6 720 615 876-16.1RS
2
3
1
6 720 615 876-17.1RS
3
4
Hide quick links:
Advertisement
Table of Contents
